How a rear hub motor works
In a rear hub motor, the wheel itself is the motor. Fixed coils sit in the middle, and a ring of magnets turns around them with the wheel.
What's inside the hub
Most modern hub motors are brushless.1 That means no small carbon blocks rub against a spinning part to feed it current. Instead, the electronics switch the current on and off.
The fixed part is called the stator. It holds the coils of wire. Per one source, the stator is fixed solidly to the axle, and the magnets are attached to and rotate with the wheel.1 The stator stays still. The magnets, and the wheel with them, are what move.
A controller feeds current to the coils in turn. Each coil pulls on the nearby magnets and then lets go as the next one takes over. Brushless motors are known for nearly instantaneous control of speed.2 The same article says a motor controller excites the coil windings.2
The brushless design has a known appeal. The general article on brushless motors lists high efficiency and low maintenance among its advantages over brushed ones.2 That's a statement about the motor type, not about any one bike.
How pedalling controls it
On a pedal-assist bike, the motor is controlled by the rider's pedalling.3 The Pedelec article describes the Japanese rules. To fulfill them, it says, an electronic controller is required to modulate the motor speed and/or torque as a function of the pedalling speed and/or torque.3 It adds that EU-defined pedelecs use this solution as well.3
Torque just means twisting force. Units and label wording are explained in reading motor labels.
So the order is simple. You pedal. The sensor notices. The controller picks a power level. The motor adds its turn to the wheel. If you stop pedalling on a bike built this way, the controller stops asking the motor for help. The settings you can choose between, such as assist levels, vary by bike, so use your own display and manual.
Why the rear wheel
One source says hub motors are usually located in the rear wheel only.1 The reason isn't given there. A front-wheel version does exist, and the page on front hub motors covers how it differs.
Some models can slow the bike
Certain hub-motor bikes can do regenerative braking. In that mode the motor operates in reverse, as a generator.1 It helps slow the bike and sends a little charge back to the battery. Not every bike has this. Look in your own manual for whether yours does and how it behaves.
What this means for owners
Because the motor is part of the wheel, the wheel is more than a plain wheel. Only the maker's manual should guide you on removing the wheel, tightening it and caring for the motor cable on your model. Don't take the motor apart.
To see this design set against the chain-driven kind, read the layout comparison.
Where the facts come from
- Electric bicycle, Wikipedia
- Brushless DC electric motor, Wikipedia
- Pedelec, Wikipedia