Skip to content

Hub motor or mid-drive: where the motor sits and why it matters

Checked 18 November 2026

The difference is one question: does the motor turn a wheel, or does it turn the cranks? Everything else follows from that.

The two layouts

With a hub motor, the motor is built into the middle of a wheel. One source puts it simply: "The bicycle wheel hub is the motor."1

That wheel is most often the rear one. The same source notes that front hub motors exist too.1 The wider hub-motor article says these motors can drive a front wheel, a rear wheel, or individual wheels.2

A mid-drive motor sits elsewhere. It's not in a wheel. Instead it drives the chain, and it's usually mounted in or under the bottom bracket shell.1 That's the part of the frame the cranks pass through. The push comes in at the pedals rather than at the wheel.1

Questions to ask about any e-bike

Before you read a spec sheet, work out which layout you're looking at. The answer decides which of the manual's sections apply to you.

  • Is the motor in a wheel hub, or down by the pedals?
  • If it's in a wheel, is that the front or the rear?
  • Does the maker give separate care notes for the chain and gears?
  • Does the manual say what to do when the motor stops helping?

You'll find the right answers in the manual for your own bike, not on this page. Makers write those steps for their own models, and their safety notes are the ones to follow.

Where the power goes in each layoutBattery sends power to the motorHub motor turns the wheel itselfMid-drive motor turns the cranksChain and gears carry mid-drive power on
A hub motor skips the chain. A mid-drive motor uses it.

What that means in use

A mid-drive sends its power through the chain, so it uses the bike's existing rear gears.1 The same source says this lets the motor work more efficiently across a wider range of speeds.1 A hub motor doesn't use those gears.

The source also says equivalent hub motors tend to be less effective at slow speeds up steep hills. It says they're less efficient at pushing the bike fast on the flat.1 It adds that some riders find a mid-drive feels smoother and closer to a bike without a motor.1 That's a feel, not a measurement, so treat it as one.

Side by side

Hub motor Mid-drive motor
Where it sits Inside a wheel hub1 At the cranks, in or under the bottom bracket shell1
What it pushes The wheel directly1 The chain, then the rear gears1
Uses the bike's gears No Yes1
Common wheel position Usually the rear, sometimes the front1 Not in a wheel

Who each one suits

Short answer? It depends.

A hub motor suits someone who wants the motor kept apart from the pedals and chain. Its power doesn't pass through the chain or the gears. That's a plain fact of the layout.

A mid-drive suits someone whose riding makes good use of gears, such as steep, slow climbs. The source says it works efficiently across a wider speed range because of them.1

Neither layout is right for everyone. Check what each maker's manual says about care and limits for the exact model you own or are considering. Three longer pages go into each layout: the rear wheel, the front wheel and the cranks.

Where the facts come from

  1. Electric bicycle, Wikipedia
  2. Wheel hub motor, Wikipedia