Skip to content

How a mid-drive motor works

Checked 18 November 2026

A mid-drive motor pushes on the crank, not the wheel. Its power then rides the same chain and gears that your legs use.

Where it sits and what it does

No wheel holds this motor. Per one source, it drives the chain from a spot usually in or under the bottom bracket shell.1 That shell is the frame part the cranks turn in. The same source says the propulsion is provided at the pedals rather than at the wheel. It is eventually applied to the wheel via the bicycle's standard drive train.1

The crank is the arm your foot pushes. The chainring is the toothed disc it turns. The chain links that disc to the sprocket on the rear wheel. A mid-drive motor adds its own turn to that same crank area, so the chain feels both your leg and the motor.

How mid-drive power travelsMotor turns the crank axle areaChainring moves the chainChain turns the rear sprocketRear wheel drives the bike
The motor feeds the same chain you pedal.

A pedal-assist bike has to mix two pushes, yours and the motor's. The mixing point is either the wheel or the crankset.2 A mid-drive is the crankset kind.

Why a freewheel matters

One source calls a freewheel crank a necessary part in mid-drive systems. It is there to allow the electric motor to work inside its optimal rotational speed range (RPM).1 A freewheel is a device that disengages one shaft from another when the driven shaft turns faster than the driveshaft.3 In plain terms, one part can spin on without dragging the other along.

Wear on the chain and gears

Mid-drive power passes through the chain and sprocket. For that reason, one source says these motors are typically held to around 250 to 500 W, to protect the drivetrain from fast wear.1 Stronger mid-drives do exist.1

The same page says most drivetrain makers now sell special chains, gears, shifters and hubs for the higher loads of e-bikes.1 Your manual will say which parts your model expects.

Gears and shifting

Some bikes pair a mid-drive with gears sealed inside the rear hub. That mix may need care, says the source, because nothing there cushions the jolt as the gears take up the drive again.1 It's a short note, and it isn't a how-to. For shifting on your own bike, follow its manual. It's the maker's guidance that counts.

What owners can take from this

Since the chain carries the motor's push, the chain, chainring and rear sprockets all sit in the power path. That's why drivetrain parts are mentioned so often alongside these motors. It doesn't tell you how long any part lasts. Your maker's manual may list what to check and how often. Follow it, and don't guess.

Mid-drive in short

Point What the source says
Position In or under the bottom bracket shell1
Power path Through the chain and sprocket1
Typical power Around 250 to 500 W, with stronger ones existing1
Needs A freewheel crank1

For a head-to-head with the wheel-based kind, go to the layout comparison. To see how a mid-drive differs from a motor in the wheel, the comparison table there is the quickest read.

Where the facts come from

  1. Electric bicycle, Wikipedia
  2. Pedelec, Wikipedia
  3. Freewheel, Wikipedia